The TkkrLab lasercutter has a smoothieboard installed because the original DSP was not very usuable, but only worked well with engraving. To turn on the lasercutter, make sure that the red power button in the back is turned on and the emergency stop is pulled up.īefore starting a lasercutter job make sure that the water cooling is running and the tiny compressor is blowing are trough the laserhead. Laser cutting Basic technical information
But the tube didn’t get the full current it needed yet.Īlthough after some tweaking the power supply that was fixed as well.Īlso to accomodate for the larget length tube, we added an extension cover to the right side of the laser cutter as well.īecause so much about the lasercutter has changed, I would call it the TK3040 or just the TkkrLab lasercutter. To connect the new power supply, a opto board was created. We replaced the lasertube for a “60 watt” 50 watt tube and a new power supply. So we opted for a smoothie clone board and replaced the DSP with that.Īfter some time running with the smoothie clone board clone, the lasertube gave out and took the powersupply with it. At had the most interesting issues with round shapes if they were not connected. The lasercutter came with a Lihuiyu Studio 6C6879-LASER-M2:6 DSP from 3wcadĪnd was only compatible with coreldraw, it was usuable for rectangle shapes and engraving bitmaps. At some point TkkrLab invested in a lasercutter to make more projects possible, the choice fell on a CW3040 lasercutter.Īlthough CW stands for Cowin the exact same model can be found made by other manufacturers as well, the only difference is the two letters in the beginning of the type.
0 kommentar(er)
